Configure DSI reports in VALD Hub

To enable ForceDecks DSI reports to be viewed from the DSI report page and added to an individual's profile, the following setup is required.

To configure DSI reports in VALD Hub:

1. Log in to VALD Hub.
2. Navigate to Dashboard in the left sidebar.
3. Select DSI Report from the dropdown at the top.

4. Click Edit Calculations.
5. Select a Numerator from the drop down options:
   1. CMJ – Countermovement Jump
   2. SJ – Squat Jump
   3. ABCMJ – Abalakov Jump
6. If applicable – Select Numerator Tags*
7. Select a Denominator from the drop down options:
   1. IMTP – Isometric Mid-Thigh Pull
   2. ISOSQT – Isometric Squat Hold
8. If applicable – Select Denominator Tags*
9. Select a Test Result from the drop down options:
   1. Max
   2. Average
10. Select a Numerator Within X Days of Denominator:
    1. ± 7 Days
    2. ± 14 Days
    3. ± 21 Days
    4. ± 28 Days
    5. ± 35 Days
    6. ± 42 Days
11. Adjust the Threshold by sliding the dots on either side of the bar
12. Click Save Calculations

Tags are created in ForceDecks app and can be applied to any recorded ForceDecks Test in the app. For more information refer to Tagging ForceDecks Tests for DSI Reports