View results with Group Dashboard charts

1. In your VALD Hub, access the Dashboard tab via the side navigation menu.
2. Click the button and select Monitoring Chart (left side). Press continue.

3. Select a VALD system.
   Currently, charts can be created for ForceDecks, ForceFrame, NordBord, DynaMo, and SmartSpeed.

4. Select a test type to show in your dashboard chart. You can use the search bar to find a particular test type.

5. Select the metric, as well as any other information depending on your system and test type (e.g. calculation type, movement, position, etc).

6. Select the laterality you want to display. The example below is for a ForceDecks test.

7. Configure any other settings.

8. Click the  Add Chart button.

Your chart will then appear as part of the Group Dashboard view. You can then click the Group(s) dropdown and choose the group(s) of profiles you wish to display.

Once you have selected your group(s) and clicked Apply selected, the dashboard chart will be populated with data. Charts can be viewed as either a graph or a table.

Graph view

Table view

Each chart will show the most recent result of each profile in that group. Results can be sorted by profile name (A - Z | Z - A) or results (low - high | high - low).

If the profile is red, that suggests that their most recent result falls below their personal average for the specified date range.

If you are wanting to compare their most recent results to a different date range, you can change this by clicking on the underlined date range at the bottom of the chart, then choosing a new personal average date range and clicking Apply changes.

Note: The personal average date range cannot be changed for DynaMo monitoring charts.

1. In your VALD Hub, access the Dashboard tab via the side navigation menu.
2. Click the button and select Quadrant Chart (right side). Press continue.

3. Select a VALD system, test type and any additional parameters for the X-axis.
   Currently, charts can be created for ForceDecks, ForceFrame, NordBord, DynaMo, and SmartSpeed.

4. Select a VALD system, test type and any additional parameters for the Y-axis.

5. Select group(s) of profiles to be analyzed within a specific date range.
   Opt for a preset time period or define your own (up to 6 months) using the custom date range function.

5. Set a comparison population. Depending on how you would like to to benchmark your data, you may choose the Group Average from an existing set of profiles, or use Manual mode to assign custom values to the axes.

7. Set the chart title – if not specified, this will default to 'X-axis metric vs Y-axis metric'.
8. Click the  Add new chart button.

Your chart will then appear as part of the Group Dashboard view.

Charts can be viewed as either a graph or a table. You can also click the Analysis group(s) dropdown to choose group(s) of profiles and update the data shown.

Graph view

Table view

In the table view, results can be sorted by profile name (A - Z | Z - A) or results (low - high | high - low).

In the quadrant view, place your mouse cursor over a dot to see the name and results of the profile. You can also hover over a profile name in the list to highlight the corresponding dot in the chart.