ForceDecks Wireless Adapter for FD4000 and FDLite V.1

The ForceDecks Wireless Adapter connects the FD4000 and FDLite V.1 force plates to a device using Bluetooth. This is useful for older styles of force plates that do not have in-built Bluetooth connectivity.

Information about the lights on the Adapter:

Turning on:

Turning off:

Charging your Wireless Adapter:

Information about the lights on the Adapter:

The first WHITE LED indicates;

• Flashing indicates starting up or powering down.
• Solid ON means the Adapter is ON and ready.
• OFF means the Adapter is OFF.

The second LED changes colour and indicates;

• Flashing indicates that the Adapter is charging – all colours.
• Solid RED indicates the battery level is too low. The Adapter will not turn on.
• Solid YELLOW indicates that the battery is moderately charged.
• Solid GREEN indicates that the battery is fully charged.
• OFF means the Adapter is OFF.

The third LED is BLUE and indicates;

• Flashing indicates pairing mode.
• ON indicates the Adapter is paired with a device.
• OFF means the Adapter is not paired with a device.

Turning on:

Press the ON/OFF button on the Adapter.

Two lights should come on - the middle LED light indicating the battery level, and a flashing white LED indicating that the Adapter is starting up. Please note that the Adapter can take up to 30 seconds to complete the start-up cycle.

Turning off:

Press and hold the ON/OFF button until the WHITE LED begins flashing to turn off the adapter. The WHITE LED will continue to flash as the Adapter powers down, then all lights out indicate that the Adapter is OFF.

Charging your Wireless Adapter:

The most efficient way to charge your Adapter is to use the enclosed cable to connect to the Adapter and then plug it directly into a wall socket.

You can also charge your Adapter while connected to the ForceDecks, but this method is much slower to charge. To do this, connect the Adapter to your ForceDecks, use the enclosed cable to connect to the Adapter, and plug it into a wall socket.

The LED lights indicator will show how much charge is in the Adapter. A full charge will provide approximately 4.5 hours of continuous use.

Follow these instructions to connect your ForceDecks Wireless Adapter.