DynaMo Plus attachment setup

The DynaMo Plus has specific attachments that can be used to perform an extremely wide variety of strength and range of motion (ROM) tests.

1. Choose the attachment

The following attachments have Near Field Communication (NFC), which enables the DynaMo Plus to automatically detect when you have connected a specific attachment.

Note: NFC enables the DynaMo device and the DynaMo app to automatically recognize the exact attachment being connected.

2. Connect the attachment

1. Turn on your DynaMo Plus device by pressing the power button until you hear a beep.
2. Open the DynaMo app on your smart device and connect to your DynaMo Plus via Bluetooth.
3. Pick up your attachment and fit the attachment into the DynaMo Plus. Line up the prongs on the attachment with the holes in the base of the DynaMo Plus. Slide in, gently pushing, then twist to lock in place.
4. The DynaMo app and the DynaMo Plus device will automatically identify the attachment. Check the display or the app to confirm the attachment was successfully identified.
5. You are ready to start testing using the relevant attachment.

3. Remove a connected attachment

1. Press the lock / unlock buttons on each side of the device together at the same time.
2. Twist the attachment to unlock it from the DynaMo Plus device.