When you receive your ForceDecks system, some assembly will be required.
What's in the box?
Need to know your ForceDecks serial numbers? Read this guide.
Positioning
Surface | It is important that the floor or surface where the platform is mounted should be as rigid as possible to minimise any vibrations. The following are examples of unsuitable surfaces:
To test the flatness of your surface, step on each corner of the platform to ensure there is no movement or rocking. |
Spacing | Leave a small gap between the left and right plate to minimise cross-interference (which can be caused by the plates touching) and a small gap between the outside edge of the safety frame. |
Interplate Cable | The orientation of the Interplate Cable determines the default Left Plate and Right Plate in the ForceDecks software. It is advised to follow the below instructions to prevent having to adjust left and right plate settings in the ForceDecks software. |
Putting it all together...
1 | Ensure you have at least a 1m (3ft) radius of clear space around the ForceDecks. |
2 | Place the ForceDecks Plates next to each other. |
3 | Plug the Interplate Cable into the ForceDecks Plates as follows:
|
4 | Plug the small end of the USB Cable into the Left Plate. |
5 | Plug the large end of the USB cable into USB port of your computer. |
6 | Push the power button on the Primary Plate - this will automatically power the Secondary Plate. |
7 | Now your plates are on, and you're all set up! |
To confirm your plates are configured correctly refer to the ForceDecks (V.2) Plate Configuration Guide.
Comments
0 comments
Article is closed for comments.