SmartSpeed Pro timing units need to be on the same channel as the SmartHub.
If your timing units have been used with a different SmartHub, you may need to change the channel of your timing units.
To set your timing units on the same channel as a SmartHub:
- There is a cursor on the SmartHub LCD display (small black square). Note where the cursor is by pressing Scroll.
- Scroll SmartHub cursor to RF Channel
- Press Enter
- Scroll to select a channel
- Press Enter to confirm your channel selection (e.g. 0x0D)
SmartHub will display ‘ Configuring RF Parameter – Please Wait’ message. Once this message disappears, your selected channel will be displayed, and your timing units should be on the same channel as SmartHub.