ForceDecks Test: Single Leg Standing Isometric Calf Raise Protocol

Before you begin

1. Zero ForceDecks - Ensure nothing is touching the plates during this step.
2. Weigh the individual - Have the individual step on the plates to measure their full bodyweight. They should NOT be touching the bar during weighing.

Assume the starting position

• Bar across the shoulders restraining upward movement.
• Chest up and looking forward.
• Active leg on the corresponding plate.
• Inactive leg lifted off the plates.

Perform the test

1. Stabilise - instruct the individual to remain completely still in the starting position for 2-3 seconds before and between each rep in the test.
2. Contract as hard and as fast as possible.
3. Hold at maximum force output for a minimum of 2 seconds.
4. Relax after the contraction.
5. Assume the starting position again.
6. Repeat steps 2 - 5 for the desired number of reps.

After completing your test, click to stop the recording and check the test results. Remember to click Upload to save your test data to VALD Hub.